Holds Doors up to 75 lbs and 2'4" (28") wide- requires two hinges Holds Doors up to 125 lbs and 2'8" (32") wide- requires three hinges
Commercial Grade Gravity Saloon Door | Cafe Door Hinges- Available in Primed, Satin Brass, Satin Chrome, Bright Chrome, Gloss Black, and Oil Rubbed Bronze Finish. Uses gravity to center the doors with ramps built inside the hardware. The doors can also be locked open in either direction. Compared to the other gravity hinges, this design allows for more of the opening to be concealed by the doors. This hardware takes minimal space, allowing for more of your opening to be covered. The ramp is concealed and lubricated to provide long lasting service. This hinge is available with a HOLD-OPEN Feature (doors will hold open when pushed to 90°) and a NON-HOLD OPEN Feature (doors DO NOT hold open). 50 lbs load rating. (Sold Individually) Hold Open Position 90° when purchased with Hold-Open Feature
Full Size Café Doors with Double Action Hardware- Are you looking for double action hinges where you can maximize the door height, we have the answer. The best hinges to allow for max height and width is the Bommer 7800 series. There are several variations of this hinge, so let us explain the hinges, so you can use the best hinge for your application. There will still be gap using these hinges, but these are the smallest gaps possible with double action hinges with full height doors. These hinges can be used for single swing doors as well as double swing doors. Max door width is 36”. Gaps will be ¼” on the sides between the door jamb and door. Gaps in the height vary based on jamb mount and floor mount. The floor mount is going to have a smaller bottom gap of 9/16"; jamb mount bottom gap is 11/16”. The top gap for both floor and jamb mount is 1/4". Gap in the center of double doors is ¼”. All gaps have a tolerance of +/- 1/8”. All hinges have a 36” max width and 90 lb door rating. Horizontal Spring Pivot: If you are mounting the doors into a traditional door opening and full height, then you will need a Bommer 7811, 7813, 7812 or 7814. The top pivot hinge will mount to the door header. Here is an explanation on the different options available.